Washer and dryer repair in Camden and Camden County for drain failures, spin problems, heating element failures, mid-cycle stops, and laundry appliance issues across all major brands. Most washer and dryer failures are single-component repairs that make financial sense to fix rather than replace. Ray gives you the honest repair-vs-replace assessment at the diagnostic visit.
Call (856) 538-2492 or use the homepage contact form with the property address, timing, photos, and access notes.
Repair vs. replace threshold: repair is almost always worth it when the cost is under 50% of a new unit and the machine is under 10 years old. Control board and motor failures on units 12+ years old often tip the calculation toward replacement. Ray gives you both numbers. Free callback: call (856) 538-2492.
“Washer was stopping mid-cycle and leaving clothes soaking wet every time. I figured I would have to replace it. Ray came out, diagnosed a failed lid switch, and fixed it for $90, a fraction of what a new washer would have cost. Wish I had not waited so long to call.”
Most washer and dryer failures, including lid switches, heating elements, thermal fuses, and pump issues, are single-component repairs that cost well under 50% of replacement. Control board and motor failures on older units are the exception. Ray gives you the repair cost and the replacement equivalent cost at the diagnostic visit so you can decide with full information.
Diagnostic: $75 credited toward repair. Most common washer repairs run $90-$300. Most common dryer repairs run $75-$200. Control board replacement is the higher end at $200-$350. Call (856) 538-2492.
Yes. Top-load failures are typically lid switches, pump failures, and belt issues. Front-load failures are typically door latches, door seals, bearing failures, and spider arm issues. Both are regularly handled in Camden County.
It is one or the other. The most common cause of slow drying is lint buildup in the internal duct past the lint trap, a cleaning issue that restores full performance in one visit. If the duct is clear, the heating element, thermal fuse, or exhaust venting may be the issue. Ray checks both at the diagnostic visit.
Yes. Gas dryers and electric dryers have different heating components, including igniter and gas valve coils on gas and heating element and thermal fuse on electric, but both are handled. Ray confirms which you have when you call.
Calling is fastest for most requests. Leave the address, what needs attention, and any timing or access notes.